After getting a Netgear Nighthawk extender setup done, you can connect to its WiFi and have internet access even in those areas of the home where you had no internet signals previously. But lately, many users have been reporting an issue with their extenders. They can connect to the internet only when they login to the extender. Otherwise, there is no internet. Are you facing the same issue? Are you looking for a remedy for the same problem? You have reached the right place. We will help you resolve the problem in a matter of minutes. Stick to reading!
Netgear Extender Not Working Without Login: Fixed
Perform a Power Cycle
The issue that you are facing right now can be because of a software glitch with the Netgear extender. Sometimes when there is a sudden power failure, the technical devices get affected by it. Similarly, when the internet gets disconnected all of a sudden, the device catches up with some minor glitch.
To get these removed from your device, you should try to power cycle it once or twice. Power cycling the entire network is also suggested if rebooting only one device does not work. Here is how you can perform a power cycle for your entire home network:
- Detach the WiFi extender from the host router.
- Now, using the power button located on the extender power it off.
- Remove the power cable also.
- Next, switch off the router and unplug it from the socket.
- Wait for some time now.
- After approximately 5 minutes, connect the extender to the router once again using an ethernet cable.
- Plug in the router and switch it on first.
- Thereafter switch on the Netgear Nighthawk extender.
Try connecting to your extender’s network now. Is it working now without having to log in?
Update the Firmware
If the issue exists even now then you should try to upgrade the firmware on your Netgear WiFi extender to the most recent version. Maybe an older version is not letting your extender work normally. So, log in to the extender on your PC and go to its settings. Check for updates and get them installed immediately. This should help you.
Reset the Extender
Is the issue adamant to leave your side? Well in such a scenario, you must reset your Netgear extender to the factory values. This will erase all the customized settings from it and restore the default settings. To reset, you should follow these steps:
- Remove the connection between the extender and the host router.
- Ensure that the extender is switched on and booted up completely.
- Find the Reset button on it and push it gently using a paper clip.
- The extender is now reset and running on the factory values.
Setup Netgear Extender
You now need to set it up once again from the very beginning. For this, you need to turn on your extender and connect your computer to its WiFi. If Netgear WiFi not working then use a LAN cable to connect the extender to the computer. Make a firm connection. Next, log in to the extender and complete the setup process by following the instructions appearing on the screen.
FYI, there are other ways that you can use to complete the setup process of the extender. It completely depends on you which method you want to go for. The information about other setup processes can be easily found in the user manual of your extender.
Right after setting up your Netgear wireless range extender, you will be able to connect to its network without any hassle. So, shift your extender to a new place and try connecting to its WiFi. Try different locations and decide the best one where you get the best possible WiFi range.